mediCAD Logo

Change Language

Web Knee

The knee module can be used to plan knee prostheses. Possible axial misalignments can be determined and corrected during planning. This makes it possible to evaluate a correction of the force application on the whole leg preoperatively and postoperatively.

Manual planning:
The following dimensions can be carried out with manual planning:
• Hip joint center over 3 points
Web Knee Manuelle Planung • Trochanter Major
• Knee base Femur
• Knee base tibia
• Ankle Joint Base
• Femoral shaft axis
• Tibia shaft axis
• Preoperative knee measurements:
   - aMPFA / - mLPFA / - mLDFA / - mMPTA / - mLDTA
   - JLCA / - AMA / - Mikulicz line
   - FSA-mTA / - mFA-mTA
• Knee correction:
   - Adjustment of the femur and tibia resection,
   and angulation
   - Varus / Valgus correction
• General measurements:
   - distance
   - Angle over 3 points
   - Angle over 4 points
Cups and shafts can then be inserted and adjusted via an intuitive implant workflow. Osteosyntheses can also be inserted.

PDF-Report:
In addition to the PACS export of a planning, mediCAD® Web offers the physician the possibility to generate a Pdf report and save it locally. This report contains all information about:
• Patient data
• OP Data
• inserted implants
• performed measurements
• Pre-operative and planning images

Directions to mediCAD

Headquarter
mediCAD Hectec GmbH
Opalstr. 54
D-84032 Altdorf/Landshut
Germany
Phone: +49 871 330203 0
Fax: +49 871 330 203 99
E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Contact form...

Branch office Bad Homburg:
Werner-Reimers-Straße 2-4
D-61352 Bad Homburg
Germany
Phone: +49 871 330203 0

Subsidiary USA:
mediCAD US, Inc.
191 Peachtree St. NE,
Suite 3720 Atlanta,
GA 30303, USA
Phone: +1 470 3441215
Mobile: +1 404 5482012